Manitowoc MII 150 Instrukcja Naprawy Pobierz pdf (Strona 17)

Installation and Service Manual

INSTALLATION

GENERAL INSTRUCTIONS FOR REMOVAL OF GEAR MOTOR

These instructions are provided as a guide for the removal of the gear motor. Depending on the model

number of your dispenser, these instructions may vary slightly.

1. Disconnect power from the electric receptacle.

2. Remove all ice from the ice storage bin of the dis-

penser.

3. Remove the paddle wheel pin from the paddle wheel

/ agitator assembly inside the dispenser bin.

4. Remove the agitator assembly from the dispenser

bin by pushing the agitator to the back of the bin.

Angle the front of the agitator to the side. Pull the

agitator forward then out of the dispenser.

5. Remove the paddle wheel from the dispenser by

pulling the hub of the paddle wheel to the back of

the bin and off the gear motor shaft.

6. Remove the splash panel from the dispenser and

expose the gear motor.

7. Disconnect the electric connector from the gear mo-

tor wire leads.

8. Remove the pin in front of the gear motor.

9. You should be able to remove the gear motor from

the dispenser.

10. To install a replacement gear motor, reverse this

procedure.

Ice

Paddle wheel

Rocking chute

ice dispense chute

Drain pan

Gear motor

Water line

Beverage valve

(option)

Removable front

merchandiser panel

Ice bin

Agitator

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Brak uwag

Manitowoc MII 150 Instrukcja Naprawy Strona 17